Adding Procedure on 3D Teeth chart 

• Select Patient.
• Select “Chart” View.

  

• Select the Procedure’s Category where the required procedure belongs to:
  
• Select the required Procedure.
  
• Select Status of procedure.
  
• Select the tooth to apply the procedure on it, by pressing on it.
  
  

Procedures in Dentalore system are classified with the treatment area, that a procedure could be performed on the mouth, a tooth, Surface, on Quadrant, Sextant, on Arch, or on a tooth range; depending on the configured settings for the selected procedure from settings.

Applying procedure on Treatment Area: Tooth Range

• Select the category where the required procedure belongs to:
  
• Select required Procedure.
  
• Select Status of procedure & then Select the tooth range to apply the procedure on it.
  Note that to select a tooth range, You should select (Press on) the first tooth then select on the last tooth you will work on it to determine the required range.
  
  

Applying procedure on Treatment Area: Arch

• Select the category where the required procedure belongs to:
  
• Select required Procedure.
  
• Select Status of procedure & then Select the required Arch (Upper or Lower) to apply the procedure on it.
  

Applying procedure on Treatment Area: Surface

• Select the category where the required procedure belongs to it:
  
• Select required Procedure.
  
• Select Status of procedure & then Select the required Surface to apply the procedure on it.
  
• if you want to apply the procedure to multiple surface, left click the first surface and then drag to other surfaces and then release the mouse